Drive sprockets
Tooth profile, mounting pattern and machine application reviewed for one-piece sprocket directions.
Undercarriage parts / Drive and guidance
Sprockets and idlers matched as working undercarriage components.
Drive sprockets transfer torque into the chain while idlers guide the track and support tension. Matching tooth or segment geometry, mounting and the surrounding track system is essential.
Who this page is for
For repair operations, equipment owners and distributors identifying replacement sprockets, bolt-on segments or front idlers for defined machines.
What can be coordinated
Define the right scope before asking for a price.
Bolt-on segments
Segment count, bolt pattern and mating geometry checked for applicable bulldozer systems.
Front idlers
Idler body, shaft, mounting and tension-system context reviewed together.
Selection & matching inputs
Send what you know.
The gaps can be clarified.
A useful first message can be short. Photographs, markings, drawings and intended-use details often prevent a visually similar but unsuitable direction.
- 01
Machine make, model and serial information
- 02
Part number, casting mark or existing supplier code
- 03
Tooth or segment count and mounting dimensions
- 04
Clear photographs of both faces and the installed position
From matching to export
The quotation should state what is—and is not—included.
Evidence-led matching
The inquiry stays open until the available model, marking and dimensional evidence is sufficiently consistent.
Order definition
Material, hardness, finish, assembly and inspection scope are stated in the confirmed order where applicable.
Export handling
Heavy components can be packed individually or consolidated with related undercarriage parts according to the route.
Can a sprocket be matched from tooth count?+
Tooth count helps but is not sufficient by itself. Mounting geometry, dimensions, markings and machine details should also be supplied.
Do you supply bolt-on sprocket segments?+
Applicable segment sets can be discussed when the machine and mounting specification are known.
Can idlers and tensioner parts be quoted together?+
Yes. Send the required assembly boundary and available measurements so the components can be reviewed as a system.